Supply, Delivery and Commissioning of Autoclave including Removal and Disposal of Existing Equipment

Description

This PIN is for the procurement of Autoclave which is vital to support all of SIPBS research and teaching activities. The service provided by this equipment is the autoclaving of biological and clinical waste and safe disposal in accordance with the Control of Substances Hazard to Health Regulations 2002 (COSHH), Genetically Modified Organisms Regulations 2014 (GMO) and The Health Technical Memorandum (HTM07-01) Safe Management of Healthcare Waste. The supplier will be required to decommission and remove the existing autoclave system, and additionally install and commission the new system within the existing space. Lot 1: Strathclyde Institute of Pharmacy and Biomedical Sciences (SIPBS) is a leader in research, teaching and knowledge exchange activities. In REF 2021, Strathclyde’s Allied Health submission was rated 100% ‘world-leading’ for its research environment, ranked joint 11th (of 91) in the UK for both its overall Research Quality and Research Power and is the highest-performing Scottish institution (THE). SIPBS MPharm and Biomedical Sciences undergraduate degrees are highly rated in the UK, with Pharmacy & Pharmacology ranked 4th in UK (Complete University Guide 2023) and Top 10 in UK for Biomedical Sciences (Complete University Guide 2023). In order to maintain this reputation, SIPBS requires a new autoclave which is vital to support all of SIPBS research and teaching activities. The service provided by this equipment is the autoclaving of biological and clinical waste and safe disposal in accordance with the Control of Substances Hazard to Health Regulations 2002 (COSHH), Genetically Modified Organisms Regulations 2014 (GMO) and The Health Technical Memorandum (HTM07-01) Safe Management of Healthcare Waste. - The supplier will be required to decommission and remove the existing autoclave system, and additionally install and commission the new system within the existing space. - SIPBS have a current footprint of 1200cm x 1900cm x 1700cm to house the autoclave. - The offered equipment must comply with all applicable H&S standards to ensure safety during all stages of equipment’s lifecycle. (Pressure Systems Safety Regulations 2000, PUWER 1998: Provision and Use of Work Equipment Regulations 1998) - The offered equipment must run continuously without user intervention to maintain the system. - All components of the offered equipment must be supplied by the awarded supplier(s), including but not limited to hardware, software, installation, and commissioning services. - The awarded supplier(s) shall provide a copy of their offered solutions infrastructure requirements including but not limited to relevant information on: dimensions, power supply, network connectivity, floor loading, etc. - The equipment must use no more than 280L per cycle water - The equipment must not use more than 10.1kw per cycle electricity." There is additional requirement that the new system is sustainable and environmentally conscious. In particular, the system should reduce water, energy consumption and carbon consumption.. The University is publishing this PIN for initial Market Research and Engagement purposes. The University may conduct further market engagement with the suppliers that note interest in this opportunity.